The short answer
To check tyre pressure, use a reliable gauge on cold tyres, compare each reading with the vehicle maker's recommended figures, and add or release air until every tyre matches. Those figures are usually on a sticker in the driver's door shut, inside the fuel filler flap or in the handbook — not the maximum pressure moulded into the tyre sidewall. Refit the valve caps and reset the tyre-pressure monitoring system (TPMS) only if your car needs it.
Before you start: what you need
Have these to hand before you kneel down at the wheel:
- The recommended pressures for your exact model, tyre size and load. The door pillar, fuel filler flap or handbook will list them.
- A tyre pressure gauge with a clear scale. Digital and dial gauges are easier to read than a worn pencil gauge, but any accurate gauge is better than a kick.
- A pump or air line if you need to add air, and a cloth for dirty valves.
- A safe, level spot off the road, ideally on your driveway before a journey.
How to check tyre pressure step by step
-
01 /
Check the tyres cold
Do this before driving, or after the car has stood for a few hours. If you have already driven, note that readings will be higher and treat them as a guide rather than a cold setting.
-
02 /
Find the recommended pressures
Look on the driver's door pillar, fuel filler flap or in the handbook. Match the tyre size and load condition. Ignore the maximum pressure on the sidewall.
-
03 /
Start with one tyre and remove the valve cap
Keep the cap somewhere safe — they are easy to lose and they keep dirt and water out of the valve.
-
04 /
Press the gauge squarely onto the valve
Push firmly and hold it steady. A brief hiss is normal. Wait for the reading to settle, then note the number.
-
05 /
Compare and record each reading
Check all four tyres, plus the spare if you carry one. Note the target and the actual figure. A small difference side to side is normal, but a tyre that is consistently lower needs attention.
-
06 /
Add or release air in short bursts
Add air a little at a time, rechecking after each burst. To release air, press the gauge or the valve pin briefly. Don't guess at the end — recheck with the gauge.
-
07 /
Refit the caps and reset TPMS if required
Screw the caps on finger-tight. If the car has a TPMS reset procedure, follow the handbook; some cars need a short drive to relearn.
-
08 /
Recheck any tyre that was low
If one tyre needed a lot of air, check it again within a few days. Repeat loss points to a puncture, a leaking valve or a damaged seal.
Find the right pressure for your car
The correct pressure is set by the vehicle maker for the car's weight and tyre size, not by the tyre brand. A family hatchback, an estate carrying a full load and a van can all need different figures. The placard often gives pressures in psi and bar; use one unit consistently and don't mix them.
- Where to look
- Driver's door pillar, fuel filler flap or handbook
- Units you may see
- psi and bar; 1 bar is about 14.5 psi
- Normal vs full load
- Use the figure for the load you are carrying
- Tyre sidewall number
- Maximum the tyre can take — not the car's recommendation
- Spare tyre
- Check the handbook for its own figure; space savers often differ
Why cold tyres give the true reading
Tyre pressure is specified cold because air expands as it warms. A tyre that has been driven at motorway speed can read noticeably higher than when it is cold. If you check after a journey, don't let air out to bring a warm tyre down to the cold figure — you'll end up under-inflated once it cools. Either check before you set off, or accept that a warm reading is only a rough check.
Adding air without overdoing it
Forecourt air lines vary; some have a preset dial, some just blow air. If there is no preset, add air in short bursts and recheck after each one. Over-inflation makes the centre of the tread work harder and can make the ride harsh; under-inflation makes the sidewalls flex more and builds heat. Both are worth correcting before a long trip.
Common mistakes and how to fix them
- Reading a warm tyre as if it were cold. Check before driving; if you have driven, use the reading only to spot a tyre that is clearly low.
- Using the sidewall maximum. Use the car's placard or handbook figure instead.
- Confusing bar and psi. Note the unit on the placard and keep to it; 1 bar is about 14.5 psi.
- Forgetting the spare. Check it at the same time, at its own pressure.
- Leaving caps off. Refit them; dirt in the valve can cause a slow leak.
- Ignoring one tyre that keeps dropping. Get it checked for a puncture, valve leak or damaged bead; repeated topping up is not a repair.
TPMS: what the light is telling you
Many cars now show individual pressures on the dashboard, but the sensors are a guide, not a substitute for a gauge. A steady TPMS warning usually means one or more tyres are below the recommended pressure; check all four cold and adjust. A flashing light often points to a system fault rather than simple under-inflation, so check the handbook. After inflating, some cars clear the warning themselves; others need a reset through a menu or a short drive.
How often to check — and when to be extra careful
Aim to check pressures at least once a month and before a long journey or a heavy load. Check more often in a cold snap, because pressure falls as the temperature drops, and after any kerb strike, pothole or noticeable handling change. Tyres also lose a little air naturally over time, so a monthly check catches slow leaks before they become a roadside problem.
When to stop and get professional help
Stop driving and get the tyre inspected if you find a bulge, a cut, exposed cords, a nail or screw in the tread, or a tyre that repeatedly loses pressure. Don't try to seal sidewall damage or a large tread puncture yourself. If a wheel is visibly flat, don't drive on it to the nearest garage unless the handbook and your breakdown service say it is safe; a flat tyre can damage the wheel and affect steering and braking.
Tyre pressure FAQs
Can I check my tyres at a petrol station?
Yes, but the tyres will usually be warm after the drive. Treat a forecourt gauge as a rough check if you can, and set the pressures cold at home or before driving. If you use the air line, add air in short bursts and recheck with your own gauge.
What pressure should I use if the door sticker and the handbook disagree?
Use the figure for your exact tyre size and load from the vehicle maker. If the two sources genuinely conflict, check with a dealer or tyre specialist; don't guess from the sidewall maximum.
Do I need to check the spare tyre?
Yes, if your car has one. Space savers and full-size spares can have their own pressures, so check the handbook or the sticker. A spare that has sat unused for months may be well below its proper pressure.
Why does the TPMS light come on when the weather turns cold?
Tyre pressure falls as the air temperature drops. If the light comes on after a cold night, check all four tyres cold and inflate them to the placard figures, then reset the system if your car requires it.
Should I let air out of warm tyres to match the cold pressure?
No. Warm tyres naturally read higher. Letting air out to hit the cold figure will leave them under-inflated once they cool. Check cold instead, or treat a warm reading as a rough guide.
How do I know if a tyre is leaking?
A tyre that needs topping up every few days, a visible nail or screw, a cut or bulge, or a hiss at the valve all point to a leak. Have it inspected rather than simply adding more air.



