Skip to content

Car care kit and maintenance essentials, chosen properly.

Fit & Fix

How to Get Engine Oil Out of Clothes: Step-by-Step Guide

Engine oil stains need blotting, not rubbing. Follow our step-by-step method for fresh and dried marks, plus fabric care and safety advice.

Fit & Fix
Mechanic in blue overalls in a garage

The short answer: lift the oil, then wash it out

Engine oil is a thick, petroleum-based grease, so water on its own will not shift it. The reliable order is to blot up the surface oil, draw more out with an absorbent powder, break the grease down with washing-up liquid, and then wash the garment at the highest temperature its care label allows.

Work on the stain while it is fresh if you can. If the oil has already dried, do not wet the garment straight away: loosen the mark with powder and neat washing-up liquid first. And keep the item out of the tumble dryer and away from a hot iron until you are certain the stain has gone.

Fresh stain
Blot, apply neat washing-up liquid, then wash as soon as practical.
Dried stain
Use absorbent powder first, then a washing-up liquid paste and a warm soak.
Wash temperature
The highest setting shown on the care label.
Drying
Air dry only until no mark remains.
Wash load
Wash oily items separately from everyday laundry.

What you need before you start

Gather these before you touch the stain:

  • Kitchen roll or a clean, light-coloured cloth for blotting
  • An absorbent powder such as cornflour, talcum powder or bicarbonate of soda
  • Washing-up liquid, the grease-cutting kind used for dishes
  • A soft brush or an old toothbrush
  • Laundry detergent; a biological or enzyme formula is useful on oily marks
  • An oxygen-based, colour-safe bleach for washable fabrics
  • A basin or bucket and warm water
  • Rubber gloves and a well-ventilated space
  • Access to a washing machine

You do not need a specialist degreaser. Washing-up liquid is designed to cut grease and is usually the most useful thing in the cupboard.

Step by step: washing out an engine oil stain

  1. 01 /

    Blot the surface oil — do not rub

    Lay the garment flat on a protected surface. Press kitchen roll or a clean cloth onto the stain and hold for a few seconds. Move to a clean patch of paper as it picks up oil. Rubbing pushes the oil deeper into the fibres and spreads the stain beyond its original edge.

  2. 02 /

    Draw out the oil with an absorbent powder

    Cover the stain with a generous pile of cornflour, talcum powder or bicarbonate of soda. Press it in gently and leave for 15–30 minutes. Brush the powder into the bin, not down the sink. This step is especially important on dried or heavy stains.

  3. 03 /

    Work in neat washing-up liquid

    Add two or three drops of washing-up liquid directly to the mark. Massage it in with your fingers or a soft brush, working from the outside of the stain towards the middle. Leave it for 10–15 minutes, but do not let it dry out completely.

  4. 04 /

    Rinse with warm water

    Hold the stained area under warm running water, or rinse it in a basin, while gently working the fabric. Warm water helps release the grease; keep it within the temperature on the care label. Rinse until the water runs clear.

  5. 05 /

    Pre-treat with detergent or oxygen bleach

    Rub in a little laundry detergent, or make a paste with oxygen-based colour-safe bleach and water if the fabric and colour allow it. Leave for 20–30 minutes. Do not use chlorine bleach on coloured or wool garments.

  6. 06 /

    Wash the garment separately

    Wash the item on its own or with other oily workwear, not with ordinary laundry. Use the highest temperature the care label permits and the full dose of detergent recommended on the pack. Avoid overloading the drum; the fabric needs room to move.

  7. 07 /

    Air dry and check before adding heat

    Hang the garment to air dry, or dry it flat if the label says so. Look at the stain in good light once it is dry. If any mark or smell remains, repeat the washing-up liquid treatment and wash again before tumble drying or ironing.

  8. 08 /

    Deal with any lingering smell

    If the stain has gone but the garment still smells of oil, wash it again with detergent and a small amount of bicarbonate of soda. Dry it outdoors if possible. Do not mask the smell with fabric softener; that can leave a film on the fibres.

Dried or set-in engine oil stains

A stain that has been sitting for days, or has already been through a warm wash, needs more patience. Start with the absorbent powder, then make a thick paste from washing-up liquid and bicarbonate of soda. Spread it over the mark, work it in gently and leave it for 30–60 minutes before rinsing.

For washable cotton and other robust fabrics, soak the garment in warm water with a full dose of detergent and an oxygen-based colour-safe bleach for 30–60 minutes. Then wash as normal. Repeat the whole process if the mark is still visible. Old oil that has been ironed or tumble dried may never come out completely, which is why heat is the last step, not the first.

Fabric by fabric: what changes

The method stays the same, but heat, agitation and bleach have to match the fabric. The care label always wins over the general guidance below.

Match the treatment to the care label and the fibre.
FabricPre-treatmentWashWatch out for
Cotton and denimNeat washing-up liquid, then detergent; oxygen bleach if colourfastWarm to hot wash as the label allowsHot washes can fade dark denim over time
Polyester, nylon and other syntheticsWashing-up liquid, then detergent; oil clings tightly to syntheticsWarm wash; avoid very high heatHeat can set both the stain and creases, so air dry
Wool and silkGentle detergent and minimal agitation; test firstHand wash cool only if the label permitsHot water and rubbing can shrink or shine the fibres
Work overalls and workshop clothingBrush off grit and treat stains before washingFollow the label and wash separately from everyday clothesOil can transfer to other items in the drum
Leather, suede and coated fabricsBlot only; do not machine washProfessional cleanWater and detergent can ruin the finish

Common mistakes and how to put them right

  • Rubbing the stain. It spreads the oil and pushes it deeper. Fix: blot, then re-treat with powder and washing-up liquid.
  • Wetting the garment before absorbing the oil. Water can carry oil further into the fibres. Fix: dry-absorb first, then rinse.
  • Using too little detergent. The oil can redeposit on the fabric. Fix: use the full dose and do not overload the machine.
  • Washing with ordinary laundry. Oil and smell can transfer. Fix: wash separately and run a hot maintenance cycle afterwards.
  • Tumble drying too soon. Heat sets the stain. Fix: air dry and inspect first.
  • Reaching for chlorine bleach. It can yellow whites and ruin colours. Fix: use oxygen-based colour-safe bleach on fabrics that allow it.
  • Skipping the care label. Fix: check the label before any heat or soak.

Safety and disposal

Engine oil, especially used oil, is not just a greasy nuisance. It can contain contaminants that irritate skin, and solvent-based cleaners bring fire and fume risks. Wear rubber gloves, keep the area ventilated and wash your hands afterwards.

Never decant petrol or other flammable solvents onto clothing. Do not mix cleaning products, particularly anything containing bleach with ammonia or acids. Keep children and pets away from the workspace.

Let solvent-soaked rags dry outdoors, then seal them in a metal container and take them to your local household waste site; do not put them in a normal bin while still wet. After washing oily clothes, run an empty hot rinse cycle in the machine to clear residual oil and odour. Check with your local council about disposing of used engine oil and contaminated absorbents.

When to stop and get professional help

Stop home treatment and take the garment to a professional cleaner if it is labelled dry clean only, is made of leather, suede, fur or a delicate embellished fabric, or if a large stain has been there for a long time. Professional cleaners have solvent processes that are not available in a domestic washing machine.

It is also worth stopping if you have treated the stain twice and it is still visible. Repeated heating, bleaching and scrubbing can damage the fibres even when the oil finally goes. A faint shadow on dark workwear is often less noticeable than the damage caused by one more aggressive attempt.

Frequently asked questions

Can I use washing-up liquid instead of a specialist stain remover?

Yes, for washable fabrics. Neat washing-up liquid cuts through grease and is a sensible first treatment. Rinse it out before you put the garment in the washing machine with detergent.

Does hot water set an engine oil stain?

No. Heat softens oil, but very hot water can shrink or damage some fabrics. Follow the care label. The bigger setting risk is tumble drying or ironing before the stain has gone.

Should I wash oily work clothes with my normal laundry?

No. Wash them separately. Oil and the smell of engine oil can transfer to other items, and the machine may need an empty hot rinse afterwards.

Why does the stain reappear after washing?

Oil can wick back to the surface as the fabric dries. If you dry the garment with heat before all the oil is out, the mark can set. Re-treat and air dry again.

Can dry cleaning remove engine oil?

Professional dry cleaning can remove oil from garments that cannot be washed at home. Tell the cleaner exactly what the stain is so they can pre-treat it.

Is used engine oil harmful on clothing?

Used engine oil can contain contaminants that irritate skin, and it should not be worn against the skin until washed out. If the garment still smells of oil after washing, wash it again.

Search