Skip to content

Car care kit and maintenance essentials, chosen properly.

Fit & Fix

How to Jump Start a Car Safely: Step-by-Step Guide

Learn how to jump start a car safely with jump leads, from preparing both vehicles to connecting and disconnecting the clamps in the right order.

Fit & Fix
Man standing beside a car with the bonnet open

The short answer

Jump starting a car means using a second vehicle with a healthy 12-volt battery, or a portable jump pack, to get a flat battery turning the engine again. It is a temporary fix, not a repair.

The safe sequence with jump leads is: park the cars close but not touching, switch both off and apply the handbrakes, connect the red lead to the flat battery’s positive terminal, then to the good battery’s positive terminal. Connect the black lead to the good battery’s negative terminal, then to a clean unpainted metal earth point on the car with the flat battery — not to its negative terminal. Start the good car, let it run for a few minutes, then start the flat car. Remove the leads in reverse order.

Before you start: what you need and when to call for help

Second vehicle or jump pack
A car with a healthy 12-volt battery, or a charged portable jump pack suitable for a 12-volt car.
Jump leads
Insulated leads with undamaged clamps, long enough to reach between the batteries without stretching.
Protective kit
Safety glasses and insulated gloves; remove rings, watches and loose metal jewellery.
Owner’s handbook
Use it to find the battery, jump-start terminals and earth point, especially if the battery is in the boot or under a seat.
Torch
Useful for finding terminals and earth points in poor light.

Check that both cars are 12-volt vehicles. Most petrol and diesel cars are, but some older vehicles and many electric or hybrid models are different. Do not use this procedure on an electric or hybrid car unless its handbook gives specific jump-starting instructions; the high-voltage system is not something to experiment with. Vehicles with stop-start systems may have a small auxiliary battery as well as the main one, so follow the handbook.

Jump starting step by step

  1. 01 /

    Check both batteries and find the jump-start points

    Open both bonnets and locate the batteries or the dedicated jump-start terminals. Read the handbook if the terminals are not obvious. Confirm neither battery is damaged and that both cars are 12-volt.

  2. 02 /

    Park safely and switch everything off

    Bring the cars close enough for the leads to reach without stretching, but do not let the bodies touch. Apply both handbrakes. Put manual cars in neutral and automatics in park. Switch off engines, lights, radio, climate control and any chargers.

  3. 03 /

    Connect the first red clamp to the flat battery

    Clamp the red lead to the positive (+) terminal of the flat battery. Rock the clamp gently to make good contact, but do not touch the other end of the lead against metal.

  4. 04 /

    Connect the second red clamp to the good battery

    Connect the other red clamp to the positive (+) terminal of the healthy battery. Keep the black lead clear of both terminals until this connection is secure.

  5. 05 /

    Connect the first black clamp to the good battery

    Clamp the black lead to the negative (–) terminal of the healthy battery.

  6. 06 /

    Earth the final black clamp on the flat car

    Connect the other black clamp to a solid, unpainted metal part of the engine or chassis on the flat car, away from the battery, fuel lines and moving parts. Use the earth point in the handbook if one is shown. Do not connect it to the flat battery’s negative terminal, and do not clamp onto a battery sensor or painted surface.

  7. 07 /

    Start the donor car and let it idle

    Start the car with the healthy battery and let it run for a few minutes. A slightly fast idle can help, but do not race the engine. If you are using a jump pack, switch it on only when its instructions say to.

  8. 08 /

    Try to start the flat car

    Crank the engine for no more than about 10 seconds. If it does not start, stop, wait two to three minutes and try once more. Do not keep cranking: it can damage the starter and drain the donor battery.

  9. 09 /

    Remove the leads in reverse order

    With both engines still running, remove the black clamp from the flat car’s earth point, then the black clamp from the good battery, then the red clamp from the good battery, and finally the red clamp from the flat battery. Do not let the clamps touch each other.

  10. 10 /

    Keep the engine running and drive

    Leave the revived car running. Close the bonnets carefully and drive for at least 20 to 30 minutes, avoiding switching off straight away. Use lights, heated screens and air conditioning sparingly on the first journey.

If you are using a jump pack

A jump pack replaces the second car, but the principle is the same: positive to positive, negative to a suitable earth point or the negative terminal only if the pack’s instructions say so. Switch the pack on only after the clamps are secure, then start the car. Keep the pack away from heat and never use one that is swollen, leaking or has damaged cables. Follow the maker’s instructions for disconnection; usually you remove the black clamp first.

What commonly goes wrong

  • Poor contact: dirty or painted terminals and clamps that are not biting can stop current flowing. Clean terminals with a dry cloth or wire brush before connecting, and clamp onto bare metal.
  • Wrong terminal: connecting positive to negative can damage electronics. Check the + and – marks and the lead colours, and never guess.
  • The final black clamp sparks: connecting it to the flat battery’s negative terminal can create a spark next to hydrogen gas. Use the earth point instead.
  • The flat battery is too far gone: if the car will not crank even with a good connection, or the battery is old and has been flat repeatedly, the battery may need testing or replacement.
  • The engine starts but dies: the charging system or battery may be faulty. Drive to a garage or call breakdown.
  • The car clicks but will not start: check the clamps are tight and on bare metal. If it still clicks, stop and seek help; it may be a starter fault rather than a flat battery.

Safety rules that matter

  • Work in a well-ventilated area and keep cigarettes, lighters and naked flames away.
  • Remove rings, watches and metal jewellery; a short circuit through metal can cause severe burns.
  • Wear safety glasses and keep your face away from the battery.
  • Keep leads away from fans, belts and hot engine parts.
  • Do not lean over the battery while making connections.
  • Do not disconnect a car battery while the engine is running on a modern car; it can damage electronic systems.
  • If it is raining, keep the leads and terminals as dry as possible and do not stand in water.

After the jump start: will it happen again?

A jump start only puts enough charge into the battery to start the car; it does not prove the battery is healthy. A short drive may not fully recharge it, especially in cold weather or with lots of short trips. If the battery is more than a few years old, or the car has been standing, have it tested. A garage can check the battery, alternator and charging system. If the car repeatedly needs jumping, stop relying on jump starts and get the fault fixed: a failing battery can leave you stranded and may affect stop-start and other electrical systems.

When to call for breakdown help instead

Call for professional help if the car is on a busy road, in a tunnel, on a motorway hard shoulder, or in any position where you cannot work safely. Also stop if you are unsure which terminal is which, if either battery is damaged, or if the car is an electric or hybrid model without clear instructions. A breakdown service can jump start or recover the car without putting you in danger.

Frequently asked questions

Can I jump start a car with a flat battery on my own?

Only if you have a charged jump pack or a suitable booster. Jump leads need a second vehicle with a healthy 12-volt battery, because the leads only transfer power; they do not store it.

How long should I leave the car running after a jump start?

Aim for a drive of at least 20 to 30 minutes rather than idling on the driveway. Idling charges the battery slowly, and short trips may not replace the power used to start the car.

Can you jump start a car with a completely dead battery?

Sometimes, but not always. If the battery is deeply discharged, sulphated or internally damaged, it may not accept a charge. A jump start may get you moving, but the battery may need testing or replacement.

Do I connect the black lead to the dead battery?

Not as the final connection. Connect the black lead to the good battery’s negative terminal, then to an unpainted metal earth point on the dead car. This keeps the spark away from hydrogen gas around the battery.

Can I jump start a hybrid or electric car?

Do not use the conventional two-car procedure unless the manufacturer’s handbook specifically says it is allowed. Many EVs and hybrids have dedicated 12-volt jump-start points and high-voltage systems that should not be touched.

Why does the car click but not start after jump starting?

A single click or rapid clicking often points to a poor connection, a flat battery that cannot take charge, or a starter fault. Check the clamps are on bare metal and tight. If it still clicks, stop and seek help.

Search